RevMedia

Set to the next value of a multivalued prompt that the window processor should move to. As MV is not used for non- associated MVs, WC_Mv_Next% is only relevant for grouped fields.

Note that an WC_Mv_Next% value greater than the total MVs in the current group plus one will move the cursor to the next prompt after the AMV group. Note further that references to running Pre Prompt for the line WC_Mv_Next% was set to, will also run the Dflt logic if there is not data in the prompt.

Default - Setting WC_Reset% to 4 will run the Pre Prompt logic for the current line, the Perpetual logic then the Pre Prompt logic for the line WC_Mv_Next% was set to. Setting WC_Reset% to 5 will repeat the above but omit the Perpetual logic.

Pre Prompt - Setting WC_Reset% to 4 will run the Perpetual logic and then the Pre Prompt logic for the line WC_Mv_Next% was set to. Setting WC_Reset% to 5 will repeat the above but omit the Perpetual logic.

Options - Setting WC_Reset% to 2 or 3 will run the Post Prompt logic for the current line, the Perpetual logic then the Pre Prompt logic for the line WC_Mv_Next% was set to. Setting WC_Reset% to 4 will repeat the above but omit the Post and setting WC_Reset% to 5 will repeat the above but omit the Post and Perpetual.

Edit - WC_Reset% does not need to be set. Will run Post then Perpetual then Pre Prompt logic for the line WC_Mv_Next% was set to at the next prompt in the group.

Post - WC_Reset% does not need to be set. Will run perpetual logic and then Pre Prompt logic for the line WC_Mv_Next% was set to at the next prompt in the group. Setting WC_Reset% to 5 will repeat the above but omit the Perpetual.

Invalid - WC_Reset% does not need to be set. However Invalid prompts behave a little strangely in 2.1 so the operation of all things Invalid related will need to be reviewed in 2.11

Softkeys - Setting WC_Reset% to 2 or 3 will run the Post Prompt logic for the current line, the Perpetual logic then the Pre Prompt logic for the line WC_Mv_Next% was set to. Setting WC_Reset% to 4 will repeat the above but omit the Post and setting WC_Reset% to 5 will repeat the above but omit the Post and Perpetual.